After a long hiatus, I'm back!!
Today, I wanted to show you a graduation card I received in a swap! Isn't it really cool? The inside is great too. Below are general instructions on how to make this card. Hope you will try it and make one for that graduate in your family. Happy Stamping! KathyGraduation Card 2014
Supplies:
Stamps
Memorable Moments
Pomp & Circumstance
Ink
StazOn Black
Cardstock
Basic Black
Whisper White
Silver Glimmer paper
Extras
Candy Dot brads
Candy Dot
Fringe Scissors
White Baker’s Twine
Star punch
Stampin’ Score with the diagonal plate
Mini glue dots
Adhesive
Dimensionals
Instructions:
Cut Basic Black cardstock 4 ¼” x 11” and score at 5 ½”. Lay the cardstock on the Stampin’ Score diagonal plate and score diagonally at 3 3/8”. Score the other side at 3 3/8”. The picture below shows the black X where you should score.
Line up one end of the scored line at the 3 3/8” mark and
score again. Flip over and score the
other side. The result is a 3” x 3”
diamond on one side of your cardstock. Cut
off the remaining area. The discarded
cardstock is shaded in the picture below.
Fold the 5 ½” scored line as a valley fold. The diagonal lines will be in a mountain fold. This will create your “cap” on the front of
your card.
For your inside Whisper White cardstock piece, cut your Whisper
White cardstock 4” x 5 ¼” and score diagonally on the 3 ¼” mark. Cut off the extra paper outside the scored
lines. It will layer into the center
area of your Basic Black cardstock nicely. Stamp
it with the graduation cap using StazOn Black ink. Add to the inside of your card and lay the
“cap” down and stamp the numbers around the cap. Stamp the congratulations at the bottom of
this piece.
The rest of the cardstock that you will need is:
·
1 piece of Basic Black cut
at 3” x 3”. This is the top of the cap. You will put a hole in the center of this
piece and add the Baker’s twine and Candy Dot brad. Add a black Candy Dot on top.
·
1 piece of Whisper White
c/s cut at 2” x 2 ¼”. This piece is used for the tassel. Cut strips on this piece using the Fringe
Scissors, leaving a ¼” area at the top.
Add adhesive at the top and roll up tightly. Add this to the other end of the Baker’s
twine. Add the completed cap to the top
of the c/s base cap using dimensionals.
·
1 piece of 2 ¾” x 2 ¾”
Whisper White c/s for the inside top part of the card. Stamp this piece with
the “Yay, You!” and the graduation scroll using StazOn Black ink. Add to the inside top area of your card and
you are done!